Pin Name IO Function Designation Function Condiition Value MIC I MIC input Input sensitivity impedance (1kHz std. dev.) Switched B output 500mVrms 100mV, 22k load DC (Battery terminal) 0.5V, 150mA max.

If writing ends successfully, the checksum is calculated and a result is displayed.

Connect the transceiver to the personal computer with 8.

If you want to continue programming other transceivers, the interface cable.

When you press the C key, the currently selected number is determined.

Press the A key so that the indicator is located on the right side, above the channel number.

Press the Side2 key when SELF is displayed.

Press the A key so that the indicator is located on Self programming mode the left side, above the zone number.

Rotate the selector select your desired zone number.

Press the B key to store the value in memory and ad- vance to the next setting.

Press the Side1 key when SELF is displayed.

The 5. Press the C key to skip any settings you do not wish to transceiver enters Function Setting Mode.

Removing the FPC 3.

How to Assemble the Antenna Connec- 1) Remove the solder from the TX-RX unit using a solder iron tor and its Terminal ( q ).

The antenna connector and its terminal are supplied as 2) Peel the double-sided tape ( w ).

After affixing the double-sided tape (5.4 x 2.7 mm) to the 5) Insert the tabs of the speaker holder into the slots of the speaker, attach the speaker to the speaker holder ( q ).

Frequency Configuration (Q703) and then applied to the lF system IC (IC701).

The first IF is system IC provides a second mixer, second local oscillator, 49.95MHz and the second IF is 450kHz.

Audio Amplifier Circuit IC13 IC12 (12) IC13 (22) The demodulated signal from IC701 is amplified by IC10, AQUA-L and goes to AF amplifier through IC13.

The signal then goes through an volume control (IC16), and is routed to an audio power amplifier (IC18) where it is MMUTE amplified and output to the speaker.

Frequency Synthesizer The control circuit consists of microprocessor (IC7) and its peripheral circuits.

IC7 mainly per- The frequency synthesizer consists of the TCXO (X501), forms the following.

Signaling Circuit The battery voltage is monitored by the microprocessor 6-1.

When the battery voltage falls be- Low-speed data (QT, DQT, LTR) low the voltage set by the Low Battery Warning adjustment Low-speed data is output from pin 30 of the CPU.

Port Name Function VREF TXD2 TXD2 (COM1) KEY2 Key matrix 2 input RXD2AINH RXD2 (COM1) KEY3 Key matrix 3 input AFDAT BB TDATA and DTRCLK.

Port Name Function BB RDFFD BB RDFFD Ref.

No. Use Function Operation Condition TCLKDTRDO BB TCLK and DTRDO Voltage detector INT 5R control Voltage regulator 5V.

When required, readjust them following Volume Volume the adjustment procedure to obtain the frequencies you want in actual operation.

KENWOOD part No.: W05-1123-00 Note: When using the battery jig, you must measure the voltage at the terminals of the battery jig.

DQT balance 1) Adj item: BAL Panel Panel Selector Make the demodu- adjust Adjust.

Sensitivity 1) Adj item: SENS Panel Panel Selector Adjust for Rotate the selector knob and adjust Adjust: knob RSSI MAX increase the adjustment value 2) Adj item: S.ENS.

Pin Name IO Function Designation Function Condiition Value MIC I MIC input Input sensitivity impedance (1kHz std.

Switched B output 500mVrms 100mV, 22k load DC (Battery terminal) 0.5V, 150mA max.

Kenwood Kpg 101D Download